Brian Powell Audio

Rebuilt Crimson 610/620

This amplifier set was created from an early 80s Crimson 610/620 pair. Besides the cases and transformer, everthing else has been replaced. The covers have been refinished in a tough fine matt black crackle powder coat. The details are:-

610

  • Refurbished main PCB with disc RIAA values trimmed to optimum.
  • Added ultra low noise pre-preamp PCB for moving coil cartridges. This can be bypassed with an internal switch. This is safe for end user to do as the preamp is classified as a low voltage device. When the MC input is in use the power amp should be sited 40cm or more from the preamp to stop induced noise. Otherwise they can be adjacently sited.
  • The disc input is via a 5 pin DIN, but a DIN to phono adaptor is included, the active sockets being red and white.
  • Fit motorised remote controlled volume control which comes with a small handset. The IR sensor is just above the volume knob. The potentiometer is a genuine Alps not a copy. The matching and sound quality are excellent.
  • The motor drive has its own power supply so that there is no motor noise breakthrough when operated.
  • The new balance potentiometer is a quality Bourns type. Balance is a fine control that does not mute either channel.
  • The two rotary switches have been replaced with gold plated types for low noise and good longevity. The top switch now has a lower gain option.
  • Increase the number of line inputs to 4. Note there is no AV as the front panel incorrectly shows (generic front panel used).
  • Low power. Off is 0.7W in the non-switching power supply, and on with the motor running is 3.4W.
  • Replace the original glue on feet with solid rubber ones screwed to the cover.
  • Replace all the knobs with solid aluminium ones.
  • Replace the original vinyl sticker rear panel with an acrylic type from a later 610. All new gold plated phonos are fitted.
  • Supply a new plugtop power unit with a 1m cable.
  • Latest on/off muting with ESD protection.

620

  • This a stereo unit with 40W per channel output and distortion below 0.01% at typical loads and levels. They will down drive loads down to 4 Ohms and electrostatic speakers.
  • The new connectors are all gold plated and are phono input and 4mm speaker output. Mains input is via fused IEC inlet socket and the cable is included.
  • The PCBs are the latest (2026) type PWR20. They feature self resetable shutdown if shorted and 70C thermal shutdown in case of overheating. These PCBs power up and down almost inaudibly and do not require heavy duty relays which can degrade the sound.
  • The green power LED flashes red if the amplifier is driven beyond its power limit, this helps the user to keep the speakers safe.
  • The wiring has been optimised to get sub 50uV output noise which is completetely inaudible.
  • The power supply capacitors are new and are 22,000 uF, twice the value of the original 10,000uF.
  • New back panel from a later model.
  • 4 solid rubber screw on feet instead of the original self-adhesive ones.
  • Low idle power of 11W.

The price is £1400 for the pair. It is possible to arrange a visit for audition, please contact me via the contact link for this or any other queries on the front page of this site.